nitriding steel
英
美 [ˈnaɪtraɪdɪŋ stiːl]
网络 渗氮钢; 氮化钢
双语例句
- The result shows that the argon gas can effectively decrease the hardness gradient and improve the thermal fatigue behavior of ion nitriding steel H13.
结果表明：氩气能有效降低渗层的硬度梯度，提高离子渗氮H13钢的热疲劳性能。 - Application of ion sputtering in plasma nitriding of austenitic stainless steel
离子溅射在奥氏体不锈钢离子渗氮中的应用 - Spalling was a major form of contact fatigue failures in nitriding steel.
氮化钢的主要接触疲劳破坏形式是剥落。 - The gas nitriding technology of H13 steel was studied by an orthogonal test.
运用正交试验法，研究H13钢气体渗氮工艺。 - The heat treatment technology of carbo-nitriding of steel has the characteristic of lower treatment temperature and direct quenching. Evolution of ultra-fine austenite grains in Nb and Nb-V-Ti microalloyed low carbon steel under cyclic heating-quenching treatment
钢的碳氮共渗热处理工艺具有共渗温度低、直接淬火等特点。循环加热-淬火工艺下超细晶奥氏体的晶粒演变特征 - Low temperature quenching of nitriding steel
钢的渗氮低温淬火 - According to the influencing power in decreasing polymer solution viscosity and in creating Fe 3+ in solution, the treating conditions are arranged in order: in carbon steel tube> in nitriding steel tube> in glass tube;
按聚合物溶液粘度下降程度和溶液中Fe3+浓度，各测试条件的影响大小排序如下：普通钢管>渗氮钢管>玻璃管； - Recent Researches on Rapid Nitriding of Steel
钢的快速渗氮技术研究现状 - Counter Measure to Crack on Surface Nitriding Steel Spares
钢中氮化铝的测定氮化钢件表面产生裂纹的对策 - Advances in the Research on Fast and Deep Case Nitriding of Steel
钢的快速深层渗氮研究进展 - Low Voltage Plasma arc Source Nitriding of Stainless Steel
等离子体弧源奥氏体不锈钢低温离子渗扩氮研究 - Low Pressure Plasma Arc Ion Nitriding of Austenitic Stainless Steel
奥氏体不锈钢低温低压等离子体渗氮 - The experimental results showed that the presence of RE could obviously accelerated nitriding process of LD steel.
结果表明：稀土对LD钢的氮化过程有明显的催渗作用； - The Effect of Discharge Temperature upon Atomic Species in Plasma Nitriding of Steel Surface
等离子体金属表面氮化中放电温度对氮原子态粒子的影响 - Study on the Corrosive Endurance of Pulse Vacuum Nitriding Coating Oil Steel
脉冲真空氮化油管钢的耐蚀性测试研究 - Monte-Carlo Simulation of Plasma-assisted Nitriding of Steel Surface
等离子体辅助的金属表面氮化的Monte-Carlo模拟 - Research and Application of Plasma Nitriding on Stainless Steel Parts
不锈钢零件表面离子渗氮的研究与应用 - Ion Nitriding of High Speed Steel with Auxiliary Heating
外加热式离子氮化高速钢的研究 - Nitrogen determination near surface of nitriding steel using nuclear reaction analysis
渗氮钢表面氮含量的核反应分析研究 - Laser nitriding of AISI 4340 steel
AISI4340钢的激光氮化 - The results indicate that it has visible effect on restraining arc discharge and hollow cathode discharge as well as ion nitriding on high-chrome steel material surface.
结果表明，交流脉冲放电在抑制弧光放电和空心阴极效应方面是非常有效的，对于高铬钢材料表面的离子渗氮作用是明显的。 - The measures of the nitriding in liquid steel are blowing N_2 and adding nitric-alloy in ladle.
钢水增氮的措施有钢包吹氮气和加含氮合金两种方式。 - Effect of Rare earth ( RE) elements on nitriding process of LD steel was studied.
研究了稀土元素对LD钢氮化过程和抗滑动磨损性能的影响。 - Solid State Nitriding of Fe-Cr-Mn Stainless Steel in 0.1 MPa Nitrogen Atmosphere at 1473K
1473K，0.1MPa氮气氛中Fe-Cr-Mn系不锈钢的固态渗氮 - Compared with nitriding steel hydrostatic guide, straightness in both horizontal and vertical directions is measured, also the stiffness of granite hydrostatic guide is measured.
最后，对花岗岩材料液压导轨展开试验研究。测量导轨水平方向和竖直方向直线度以及导轨油膜刚度，并与氮化钢液压导轨进行对比。